• Wan Power Tech

    Lifting Malaysia Since 2007

    Elevators, escalators and electrical equipment — installed, serviced and maintained by a team with 18+ years on site.

    Follow Us

    • Home
    • >
    • Wireless Solutions

    Wireless Solutions

    Wireless elevator monitoring and intercom — retrofit-friendly
    technology that needs no rewiring

    Powered by Attollo

    Revolutionizing elevator
    safety & efficiency

    Traditional wired lift systems are expensive to install, awkward to troubleshoot when a cable
    fault is hidden in a wall, and difficult to expand. Wireless changes that. These systems retrofit
    into existing buildings with no structural changes — which matters most in older and
    heritage buildings where rewiring would be disruptive or simply not permitted.

    Real-time touchscreen status tracking for every lift in the building. Communication is IP-based, so it does not depend on the lift manufacturer’s protocol. Includes log-entry viewing, remote diagnostics, multi-location deployment and a customizable interface.

    A camera-equipped intercom speaker inside the lift car, linked to an indoor touchscreen at the control room. Voice and data exchange runs over a secure wireless protocol, and installation is plug-and-play — no structural changes.

    40% lower installation cost, because there is no complex cabling and far less labour. 99.9% uptime with encrypted signals. Sensors and units can be added in minutes rather than days, and the same backbone extends to CCTV and PA systems.

    Retrofit-friendly by design. No visible wiring on the facade, no exposed underground or overhead runs that carry lightning-strike risk, and no downtime while walls are opened up.

    FUJISJ and Attollo partnership

    Plug-and-play, no structural changes

    IP-based, no lift-protocol dependency

    Extensible to CCTV and PA systems

    What the wireless
    approach actually saves.

    40% lower install cost

    No complex cable runs means less labour and
    less time on site, compared with an
    equivalent wired installation.

    99.9% uptime

    Encrypted wireless signals keep the link
    between car, control room and monitoring
    station reliable and secure.

    Minutes, not days, to scale

    Adding another lift, sensor or unit does not
    mean opening walls — the system extends
    without new cabling.

    Why buildings switch

    No new cable. No closed lifts.

    A wired retrofit means opening walls, running conduit and taking lifts out of service while it happens. Wireless avoids all three — 40% lower installation cost, 99.9% uptime on encrypted signals, and new units added in minutes rather than days.

    Real deployments

    Already running in a KL
    hospital, a 26-lift Sabah
    building, and WD Kuching.

    26

    Lifts covered in a single
    Sabah deployment

    Safety critical

    Trusted in a Kuala Lumpur hospital
    across 11 lifts

    Tell us what needs lifting,
    fixing or maintaining

    Call us, or send through the details of your building and equipment.
    We will arrange a site assessment and come back with a written quotation.